Bending tool 6.0-10.0mm For bending and forming from wire and metal strips/pieced(photo etch). Due sepperate sizes, you are allowed to bend repeatly with the same curve Size:6.0/7.0/8.0/9.0/10.0 mm

Bending tool 1.5-5.0mm For bending and forming from wire and metal strips/pieced(photo etch). Due sepperate sizes, you are allowed to bend repeatly with the same curve Size:1.5/2.5/3.5/4.5/5.0 mm

Photo Etched parts Bender (Small) with two bending aids. Has been specially developed for model building using photo etch parts allowing the brass to be held and bent accurately into many different shapes. Measures 59mm x 59mm

Photo Etch Pencil Has a slightly sticky tip, to pick and place small parts without shooting away. If the tip is not sticky or sharp anymore it can be scharpened with a regular pencil sharpener.

Photo Etched parts Bender (Large) with 4 bending aids. Has been specially developed for model building using photo etch parts allowing the brass to be held and bent accurately into many different shapes. Measures 79mm x 162mm

Bending springs for tubes For evenly bending brass, copper and tubes without kinking. Beforehand, the part of the tube to be bent must be softened by heating it with a flame. Then let the tube cool down. After cooling, the bending can begin. Method: S

Doming punch set with doming block 12 doming punches in the sizes: 2.3 - 3.5 - 4.3 - 5.1 - 5.9 - 6.7 - 7.5 - 8.3 - 9.1 - 9.9 - 10.7 - 11.5mm. Manufactured from hardened tool steel Doming block: Manufactured from hardened and polished tool steel